MM aqua is into manufacturing and supplying of various types of fill design to suit diffrent water quality.these fill media are manufactured as per recomendation of CTI. |
Fill media manufacturted by us of international quality and are prefered by leading consultants like NTPC , MNDASTU , DESIN , FISTER , TCE , EIL etc and leading OEM s of cooling towers.
|
Our fill media are exported to countries like Canada , Australia , Malasiya etc.
MM Aqua has long production capacity to meet large order Qty in required project schedule. |
Almost in all industries they prefer to take water clarifier & De-minrelisation plant which allows the use of filmfill. But in case where sea water or bad water quality, it is prefered to opt
splash fill. |
|
| MM Aqua offers following type of fill media . |
|
| • Film Fill : - C 10.12 / 10.19 / 10.27 FC 33.12 /33.19 / 33.27 / 33.01 |
| • Spalsh Fill :- V bar Circular / Rhumbus of 1.2 & 1.5 mm thick. |
| |
| MM Aqua has home of supply 23 lack meter of single order of V bar in stipulate delivery time. |
|
Film Fill / PLASdek |
 |
|
Advantage of film fill. |
| Continous Forming : Continous forming process is adopted by us where one end of fill is always free & material supply from other end is always available during the time of formation. Additional requirement of raw material is met hence no thinning effect takes place at crests & troughs. |
| Double Edge Folding : MM Aqua's manufacturing technique has the ability to fold the edges of the sheets providing stronger edges, which gives extra protection against rough handling during installation & maintenance. It also protects the fill from erosion. |
| Uniform Thickness : Uniform thickness provides long retention time & also provide uniform time for heat transfer. |
| Longer Length : One major advantage of Longer length is that, it allows the water to be inside the fill media for maximum time. It also facilitate to decrease the number of support beam thus inturn reduces the pressure drop & also reduces the cost of construction. |
|
Salient features of film fill . |
| 1. Continous Forming |
| 2. Double Edge Folding |
| 3. Uniform Thickness |
| 4. Available in sheet width of 300mm / 600 mm i.e. fill media in cooling tower is acting by 3- 5 layer which is placed perpendicular to eachother. In case of damage, particular one block can be replaced easily. |
|
|
Type |
C10.12 |
C10.19 |
C10.27 |
Flute Size |
12mm |
19mm |
27mm |
Surface of Exchange |
243m3 |
148m2/m3 |
112m2/m3 |
Min. Waterload |
8m3/m2h |
5m3/m2h |
3m3/m2h |
Material Thickness |
0.175/0.20mm |
0.2/0.25mm |
0.35/0.40mm |
Weight |
35kg/m3 |
27kg/m3 |
28kg/m3 |
Field of application |
Cross flow & Counter - flow processes |
|
|
| |
| Distance of Support |
Max 1000mm |
| Width of Supports |
50mm |
| Material |
PVC |
|
| In Conventional vacuum forming requires anchoring both ends of the sheet, with resulting material stretch. Weak spots -even pin holes are the inevitable results. Vacuum-formed sheets suffer from unpredictable thikness due to material stretching during the process. Thiknesses will diminish by an average of 30%. By leaving one end free during continuous roll forming, MM Aqua avoids the undesirable results. |
|
Splash bars are normally used throughout the height of a cooling tower 
